Focus on SMT chip processing, circuit board welding
processing and test assembly
Guangzhou Xinlianxin Electronic Technology Co., Ltd.
Contact: Mr. Zhang
Phone: 18675895421
Email: 2606065393@qq.com
Address: First Floor, No. 98 Jianshe Road, Taoyuan West Street, Junhe, Baiyun District, Guangzhou
Today we will talk about the precautions of SMT chip processing plants, because SMT chip technology is known by more and more people, and some factories mainly focus more on the production process and production process of the product when doing SMT processing. Therefore, the factory environment is often ignored. I think that only by adjusting the processing environment on the basis of the previous two points can the SMT processing line be more efficient and secure.
As the so-called safety first, production second, the same is true for SMT chip processing. The level of production lines is constantly improving, and the degree of mechanization has been greatly improved, but there are also many links that require manual operation. Because SMT processing technology adopts the method of in-line installation, usually in the production process, the entire SMT production line is generally long, so we have to pay attention to the carrying capacity of these machines.
The plant's bearing capacity is limited. If you don't pay attention to the plant's ground bearing capacity, it may cause hidden dangers such as ground cracking. As a result, production efficiency is affected, and even an irreversible negative effect on the company's reputation.
Another issue that needs to be paid attention to is the power supply of the plant to see if it can carry the needs of the entire equipment. The power supply voltage requirement for SMT processing is relatively large, for this reason, the voltage of the plant must be tested to ensure the normal operation of the equipment. Even if the equipment runs occasionally and encounters welding and other links, the product quality cannot be guaranteed, which seriously affects production.
The start-up environment of the equipment should be in a clean and dry condition. If the operating environment of the equipment is wet and untidy, it will cause the equipment to be blocked, which will affect the service life and work efficiency of the equipment. It should be noted that the machine will produce vibration during operation, so the staff must pay attention to these links.
However, if it is found that the vibration amplitude of the SMT processing equipment is beyond the general range, then it must be vigilant and require relevant personnel to perform maintenance. If the quality of the plant is not good, the excessive vibration will affect the use of the plant and may make the operator feel uncomfortable. As a result, not only the production efficiency is reduced, but also production accidents are more likely to be caused.
Anti-static measures during SMT patch processing must be in place. This is a relatively important step. For this reason, attention must be paid to the whole process in the production process. Normally, the production line is already equipped with an anti-static system, but operators who lack knowledge must be properly trained.
In summary, the above plant carrying capacity, power supply issues, equipment startup environment requirements and vibration amplitude, and anti-static measures are all detailed issues, and generally only workers will know. The precautions for SMT patch processing plants, few people know these details and will introduce you here, only if we do safety first, production second and take good care of the details, can we ensure the smooth progress of SMT patch processing.